Electrical Components Disassembly - Pioneer QUANTUM INVERTER Series Service & Troubleshooting Manual

3.2

Electrical Components Disassembly

Antistatic gloves must be worn when you disassemble the electronic box.
WARNING:
Note: Remove the air outlet grille (refer to 3.1 Panel Plate Disassembly) prior to disassembling electrical parts.
3.2.1. Electronic Control Box Subassembly Removal (EW-1, EW-2)
YN009GMFI22RPE / YN009GMFI20RPD / YN012GMFI22RPE / YN012GMFI20RPD / YN018GMFI20RPD
Procedure
1) Disconnect the connector for
compressor and release the ground
wire (1 screw, for some models )
See Fig. 1).
2) Remove the electronic control
box subassembly (see Fig. 2). .
Note: Electric control box cover
cannot be removed.
Note: This section is for reference only. Actual unit appearance may vary.
YN009AMFI22RPE / YN009AMFI20RPD / YN012AMFI22RPE / YN012AMFI20RPD
Illustration
Outdoor Unit Disassembly

Scope of Models Covered:
Figure 1
Figure 2
16
