Pioneer QUANTUM INVERTER Series Service & Troubleshooting Manual page 108

Procedure
3) Remove the hex nuts and washers that
secure the compressor, located on the
bottom plate (see Fig. 3).
4) Heat up the brazed parts and then remove
the discharge pipe as well as the suction
pipe (see Fig. 4).
5) Lift the compressor from the base pan
assembly by using pliers.
Note: This section is for reference only. Actual unit appearance may vary.
Illustration
Discharge Pipe
Outdoor Unit Disassembly

Figure 3
Figure 4
25

Suction Pipe