Working Mode - Komatsu ecot3 Operation And Maintenance Manual

OPERATION

WORKING MODE

Working Mode
Use working mode selector switch (1) to select the working mode that matches the operating conditions or purpose.
This will make it possible to carry out operations efficiently.
Use the following procedure to select the most efficient working mode.
When the starting switch is turned ON, the working mode is set to the mode that was in operation when the starting
switch was last turned OFF.
Use the working mode switch to set the mode to the most efficient
mode to match the type of work.
Working
mode
Normal digging or loading operations
P mode
(operations with emphasis on production)
Normal digging or loading operations
E mode
(operations with emphasis on fuel consumption)
L mode Aligning position (fine control operations)
B mode Breaker operations
Operations with the crusher or other
ATT mode
double-acting action attachment
NOTICE
If breaker operations are carried out in a mode other than the breaker mode, there is danger of breakage of the hydraulic
equipment. Do not carry out breaker operations in any mode except the breaker mode.
1. If working mode selector switch (1) is pressed, the working
mode selection screen is displayed on the monitor.
Applicable operations
MACHINE OPERATIONS AND CONTROLS
3 - 157