Lifting Machine - Komatsu ecot3 Operation And Maintenance Manual

TRANSPORTATION

LIFTING MACHINE

The operator carrying out the lifting operation using a crane must be a properly qualified crane operator.
Never raise the machine with any worker on it.
Always make sure that the wire rope is of ample strength for the weight of this machine.
When lifting, keep the machine horizontal.
When carrying out lifting operations, set the lock lever to the LOCK position to prevent the machine from moving unexpectedly.
Never enter the area under or around a raised machine.
Never try to lift the machine in any posture other than the posture given in the procedure below or using lifting equipment other
than in the procedure below.
There is a hazard that the machine may lose its balance.
NOTICE
This method of lifting applies to the standard specification machine.
The method of lifting differs according to the attachments and options installed.
For details of the procedure for machines that are not the standard specification, please consult your Komatsu distributor.
For weight, see "SPECIFICATIONS (PAGE 5-2)".
When lifting the machine, carry out the operation on flat ground as follows.
Standard Specification Machine
1. Start the engine, then the swing the upper structure so that the work equipment will be on the side of sprocket
(1).
2. Extend the bucket cylinder and arm cylinder fully, then lower
the work equipment to the ground as shown in the diagram on
the right using the boom cylinder.
3. Set the lock lever securely to the LOCK position (L).
4. Stop the engine, check that there is nothing around the operator's compartment, then get off the machine.
Close the cab door and front glass securely.
3 - 186
WARNING
OPERATION