Copying Menu Settings Between Base Units (Batch Setup); Transferring Settings From A Usb Flash Drive - Epson ELPWP20 User Manual

Copying Menu Settings Between Base Units (Batch Setup)

After selecting the base unit's menu settings for one base unit, you can use the
following methods to copy the settings to other base units, as long as they are
the same model.
• by using a USB flash drive
• by connecting a computer and base unit using a USB cable
You cannot copy any information unique to an individual base unit, such as
Operation Hours or Status.
Make sure Batch Setup Range is set to Limited if you do not want to copy
the following settings:
• Password Protection settings
• Network menu settings
Management > Batch Setup Range
s
Caution
Epson takes no responsibility for batch setup failures and associated repair costs due
to power outages, communication errors, or other problems that may cause such
failures.
Related Links
g
• "Transferring Settings From a USB Flash Drive"
• "Transferring Settings From a Computer"

Transferring Settings From a USB Flash Drive

You can copy menu settings from one base unit to another of the same model
using a USB flash drive.
p.95
p.96
• The USB flash drive must use a FAT16/32 format and not incorporate
any security function. Delete any files on the drive before using it for
batch setup or the settings may not be saved correctly.
• You can also use this batch setup method from the base unit's menu.
a
Disconnect the AC adapter from the base unit, and check that base unit's
indicator has turned off.
b
Connect an empty USB flash drive directly to the base unit's USB-A port.
c
Hold down the [Esc] button on the remote control and connect the AC
adapter to the base unit.
d
When the base unit's indicator turns on, release the [Esc] button.
The indicators start flashing and the batch setup file is written to the USB
flash drive. When writing is finished, the base unit turns off.
Caution
Do not disconnect the AC adapter or the USB flash drive from the base
unit while the file is being written. If the AC adapter or USB flash drive is
disconnected, the base unit may not start correctly.
e
Remove the USB flash drive.
The file name for the batch setup file is PJCONFDATA.bin. If you
need to change the file name, add text after PJCONFDATA using
only alphanumeric characters. If you change the PJCONFDATA
section of the file name, the base unit may not be able to recognize
the file correctly.
f
Disconnect the AC adapter from the base unit to which you want to copy
settings, and check that the base unit's indicator has turned off.
95