Table of Contents
Advertisement
To change a parameter, highlight it and press the backspace toggle between
Yes and No.
5.
Highlight Start and press Enter.
If necessary, you can pause and resume or stop and restart the Redundancy
Check. You can use the logical drive while Redundancy Check is running.
Locating a Logical Drive
This feature helps you identify the physical drives assigned to the logical drive
you are working with in the CLU. To locate a logical drive:
1.
From the Main Menu, highlight Logical Drive Management and press Enter.
2.
Highlight the disk array you want and press Enter.
3.
Highlight Locate Logical Drive and press Enter.
The disk status LEDs for the physical drives in this logical drive blink for one
minute.
Figure 9. Disk Status LED
Chapter 6: Management with the CLU
241
Disk Status
Advertisement
Table of Contents
