Adjustments; Adjusting The Right Y-Cutting Position (Border Mode) - Brother LX-300 Service Manual

6.3 Adjustments

6.3.1

Adjusting the Right Y-cutting Position (Border Mode)

1. Before adjustment, laminate in the Border Mode to check the amount of border.
2. Turn off the power supply and pull the AC adapter jack from the unit.
3. Turn on the power, then turn the dial switch to the Border position.
4. Loosen screws 1 and 2 and move Adjustment plate in the direction of the arrow
indicated in the diagram below. This moves the Y-cutter attached to the Y-cutter
guide to adjust the cutting position for the right edge of the film.
In the diagram below, move the Adjustment plate to the right to increase the margin
between the film and the document.
5. After adjustment, tighten Screw 2, then tighten Screw 1. Laminate a test document
to check if the amount of border has improved.
6. Repeat steps 2 to 5 until the borders are correct.
If the right border is adjusted in the Border Mode, the No Border mode is
adjusted simultaneously, so do not adjust again in the No Border mode.
Screw 1
Screw 2
Fig. 6.3-1 Adjusting the Right Y-cutting Position
6-18
Y-cutter guide
Adjustment plate
CL2000010