X-Cutter Unit; Removing The X-Cutter Unit; Removing The Leaf Switch F Assy - Brother LX-300 Service Manual

3.6 X-cutter Unit

3.6.1

Removing the X-cutter Unit

1. Remove the Y-cutter assy.
2. Remove the two X-cutter screws. Move the X-cutter unit toward the right to remove
it.
∗
Remove the Chassis assy from the Bottom cover when replacing the X-cutter
unit.
3.6.2

Removing the Leaf Switch F Assy.

Remove the Leaf switch F screw, then remove the Leaf switch F assy.
∗
Take care not to bend the connector root on the Leaf switch F assy harness.
Y-cutter assy
X-cutter unit
Fig. 3.6-1 Removing the X-cutter Unit
X-cutter unit
Tape sensor holder
Fig. 3.6-2 Removing the Leaf Switch F Assy
3-18
X-cutter screws
Leaf switch F assy
Leaf switch F screw