Adjusting The Left Y-Cutting Position - Brother LX-300 Service Manual

6.3.2

Adjusting the Left Y-cutting Position

1. Before adjustment, laminate in the Border Mode to check the amount of border.
2. Turn off the power supply and pull the AC adapter jack from the unit.
3. Loosen the screw and move the Y-sensor carriage arm left or right. This moves the
detection position of the sensor attached to the Y-sensor carriage and adjusts the
cutting position for the left edge of the film.
In the diagram below, move Y-sensor carriage arm to the right to increase the
margin between the film and the document.
4. After adjustment, tighten the Screw. Laminate a test document to check if the
amount of border has improved.
5. Repeat steps 2 to 4 until the borders are correct.
If the left border is adjusted in the Border Mode, the No Border mode is adjusted
simultaneously, so do not adjust again in the No Border mode.
Y-cutter arm
Y-sensor carriage arm
Fig. 6.3-2 Adjusting the Left Y-cutting Position
6-19
Y-sensor carriage
Screw
CL2000010