Main Chassis B; Removing The Main Chassis B - Brother LX-300 Service Manual

3.17 Main Chassis B

3.17.1 Removing the Main Chassis B

1. Disengage the harness from the hooks under the Cassette holder and the Edging
saddle at the rear of the main chassis B.
2. Remove the Edging saddle from the rear of the main chassis B.
3. Remove the tape holding the ENC sensor harness.
4. Remove the Leaf switch C3/C4 screws, then remove the Leaf switch C3/C4
assemblies.
5. Remove the two Cassette actuators.
Leaf switch C3 assy
Leaf switch C3 screw
Cassette actuator
Leaf switch C4 screw
Leaf switch
C4 assy
The bottom face of cassette holder
Fig. 3.17-1 Removing the Main Chassis B
3-33
Cassette holder
Harness
Rear of the main chassis B
ENC sensor
ENC sensor harness
Tape
Edging saddle