Disassembling The Y-Sensor Rail Unit - Brother LX-300 Service Manual

3.8.2

Disassembling the Y-sensor Rail Unit

1. Remove the Retaining ring from the Y-sensor shaft, then pull out the Y sensor shaft.
2. Remove the FPC holder A from the Y-sensor rail, then remove the Y-sensor
carriage.
Retaining ring
Y-sensor rail screw
FPC holder
Y-sensor rail
Y-sensor rail screw
Fig. 3.8-2 Disassembling the Y-sensor Rail Unit
3-22
Y-sensor carriage
Paper feed
film
FPC holder
Retaining ring
Y-sensor shaft
Reinforcement
film