Adjusting the Image Shape
In most cases, you can maintain a square or rectangular image by
placing the projector directly in front of the center of the screen with
the base of the lens level with the bottom of the screen.
If the projector is slightly tilted (within a range of 30° up or down),
you can use the
Keystone
projector's Keystone menu (see "Using Keystone Correction" on
page 37) to correct vertical keystone distortion.
Projector tilted up
If your image is shaped like
to one side of the screen at an angle. Place it directly in front of the
center of the screen, facing the screen squarely.
Using Keystone Correction
To adjust your image when it is wider on the top or bottom, do the
following:
Press the
or
■
satisfied with the shape of the image.
keys on the projector's control panel or the
Corrected image
or
, you've placed the projector off
buttons on the projector until you are
Projector tilted down
Keystone
buttons
note
The image will be slightly
shorter after adjusting.
Projecting
37