Monitoring Your Projectors - Epson PowerLite 6110i User Manual

note
To monitor a projector
when it's in standby mode
(plugged in but not turned
on), you must select
as the
Network On
setting in
Standby Mode
the projector's menu system
(see page 61).
For detailed status
information, right-click the
projector and click
.
Property
note
To create projector groups in
EMP Monitor, refer to the
on-screen Operation
Guide.
Monitoring the Projector Over a Network
80

Monitoring Your Projectors

The EMP Monitor screen lets you monitor your projector(s) status
and check if a problem has occurred.
For the most current status, click the
The following table describes the EMP Monitor status icons:
Group status icons
No warnings or problems. All projectors in the group
are operating normally.
Warning or problem. A projector in the group has a
warning or problem.
Notification. A projector in the group requires
immediate attention.
Monitoring disabled. Right click the icon and select
Monitoring Enabled to begin monitoring the group.
Data is currently being updated.
Type status icons
No warnings or problems.
Warning or problem.
Notification.
Monitor Password error. No monitor password was
entered when the projector was registered, or an
incorrect password was entered.
Monitoring disabled. Right-click the icon and select
Monitoring Enabled to begin monitoring the
projector.
Data is currently being updated.
Network error (for example, the projector is not
connected to the network, or power cable is
disconnected).
You may also see this error if Network Off is
selected in Standby Mode (see page 61).
Network error (Esc/VP.net communication error).
button.
Refresh