Panasonic MEW01091 Operating Instructions Manual page 6

Panasonic Electric Works Nordic AB
MEW01091 Rev: 3
25.2 Disable zone / address (H2/B2) _______________________ 83
25.3 Disable output (H2/B3) _____________________________ 84
25.4 Disable all control, extinguishing, ventilation and alarm device
outputs (H2/B4) _________________________________________ 85
25.5 Re-enable zone (H2/B5) ____________________________ 86
25.6 Re-enable zone / address (H2/B6) _____________________ 87
25.7 Re-enable output (H2/B7) ___________________________ 88
25.8 Re-enable all control, extinguishing, ventilation or alarm
device outputs (H2/B8) ___________________________________ 90
25.9 Disable or re-enable outputs for routing equipment (H2/B9) 91
25.10 De-activate alert annunciation function (H2/B10) ______ 92
26 Set calendar and clock (H3) __________________ 93
26.1 Daylight saving time _______________________________ 94
27 Present system status on display (H4) __________ 95
27.1 Disablement (H4/U1) ______________________________ 95
27.2 Disablement by time channel (H4/U2) _________________ 96
27.3 Sensor values (H4/U3) _____________________________ 97
27.3.1 Reset of a week average sensor value ______________ 99
27.4 Sensors activating SERVICE signal (H4/U4) ___________ 100
27.5 Event log (H4/U5) ________________________________ 101
27.6 Show configuration and alarm counter (H4/U6) _________ 102
28 Service (H5) ______________________________ 103
28.1 Access code for service and maintenance ______________ 104
Disconnect / Re-connect COM loop (H5/A1) _________________ 105
28.2 Disconnect / Re-connect zone line input (H5/A2) _______ 106
28.3 Calibration of supervised outputs (H5/A3) _____________ 107
28.4 Sensitive fault detection mode (H5/A4) _______________ 108
28.5 Service mode for COM-loop (H5/A5) ________________ 109
28.6 Show information about Site Specific Data (H5/A6) _____ 111
28.7 Display current consumption on COM loop (H5/A7) _____ 112
28.8 Display statistics for COM loop (H5/A8) ______________ 113
28.9 Activate address setting mode for DU (H5/A9) _________ 114
29 Acknowledge FAULTS (H6) ________________ 115
30 Perform ZONE TEST (test mode) (H7) _______ 116
31 Maintenance (H8) _________________________ 118
31.1 Access code for service and maintenance ______________ 118
31.2 Acknowledge SERVICE signal (H8/S1) _______________ 119
31.3 Restore weekly average to default (H8/S2) _____________ 120
31.4 Test of alarm devices (H8/S3) _______________________ 121
31.5 Safe shut down of control unit (H8/S4) _______________ 122
31.6 Activate address in alarm mode (H8/S5) ______________ 123
31.7 Change access code for service and maintenance (H8/S6) _ 125
31.8 Change access code for PC-communication (H8/S7) _____ 126
32 Interlocking outputs and inputs (H9) _________ 127
4
EBL128 Operating Instructions V1.1.x