Disable Or Re-Enable Outputs For Routing Equipment (H2/B9) - Panasonic MEW01091 Operating Instructions Manual

Panasonic Electric Works Nordic AB
MEW01091
25.9
Action
"Access"
Scroll to menu H2.
"A"
Scroll to menu B9
"A"
"A"
Rev: 3
Disable or re-enable outputs for routing
equipment (H2/B9)
Disabled outputs are listed in menu H4/U1.
Outputs for routing equipment (fire brigade tx / fault tx) can be
disabled and re-enabled via this menu. Disabled output will stay
disabled, until re-enabled again via this menu. Can be useful during
an installation and test period, when only local alarms are required.
Disabled output is indicated by LEDs "Disablements" (L8) and "Fault
/ Disablements Fire brigade tx" (L15).
Text in display
Disable or re-enable
Disable zone
Disable or re-enable outputs for
routing equipment
Routing equipment for FIRE:1, FAULT:1
(1=enabled, 0=disabled)
Disable or re-enable outputs for
routing equipment
EBL128 Operating Instructions V1.1.x
ACCEPT? H2
ACCEPT? B1
ACCEPT?
ACCEPT?
ACCEPT?
91
Comments
According to chapter
"Access", see page 78.
B9
To move the cursor, press
"". Edit and/or press "A"
to accept.
Scroll or press "Return" to
B9
return to H2. Scroll or
press "Return" to log off.