Acknowledge Service Signal (H8/S1) - Panasonic MEW01091 Operating Instructions Manual

Panasonic Electric Works Nordic AB
MEW01091
31.2
Action
"Access"
"A"
"Fault acknowledge"
"Return"
Rev: 3

Acknowledge SERVICE signal (H8/S1)

See chapter "Sensors activating SERVICE signal (H4/U4)", page 100.
When a sensor (analog smoke detector) that has generated SERVICE
signal is acknowledged, the sensor will be given a default sensor value
as for a new / clean sensor, i.e. first replace the sensor then
acknowledge the service signal as soon as possible.
The very first week average sensor value after the SERVICE signal is
acknowledged will be calculated within one hour. Thereafter a new
week average sensor value will be calculated every week.
NOTE! If a sensor is replaced without activating service signal, it has
to be reset to the default sensor value via menu H8/S2, see chapter
"Restore weekly average to default (H8/S2)", page 120.
Text in display
Acknowledge SERVICE signal
Sensor : xx-xx (technical address xxx)
needs service
The service signal for that sensor is now acknowledged and
the next sensor will be shown in the display.
Sensor : yy-yy (technical address yyy)
needs service
Acknowledge SERVICE signal
LED "Service" (L12) will be turned off when all sensors have been
acknowledged.
EBL128 Operating Instructions V1.1.x
ACCEPT? S1
ACCEPT? S1
119
Comments
According to chapter
"Access code for service
and maintenance", see
page 118.
If there are no sensors to
L
acknowledge, menu S1
will be shown again.
L = a list in which you can
scroll. If it is the correct
sensor to acknowledge,
press "Fault acknowledge".
If not, scroll or write the
wanted sensor and press
"Fault acknowledge" or
press "Return" to S1.
If more service signal
acknowledgements shall
be done, continue like
above. If not, press
L
"Return" to menu S1.
Scroll or press "Return" to
menu H8. Scroll or press
"Return" to log off.