Alert Annunciation Alarm (Aa Alarm) - Panasonic MEW01091 Operating Instructions Manual

Panasonic Electric Works Nordic AB
MEW01091 Rev: 3
16.2.1.7
16.2.1.8
16.2.1.9
16.2.2
001 ZONE-ADDR 12-45 LAST ZONE 12
Re-enable zone: ZZ
This is a list of disabled zones. Scroll to or write the wanted zone
number and press "A". If more zones are to be re-enabled, repeat the
procedure.
Re-enable zone / address (X7)
001 ZONE-ADDR 12-45 LAST ZONE 12
Re-enable zone / address
Press "A". E.g.:
001 ZONE-ADDR 12-45 LAST ZONE 12
Re-enable zone: ZZ Address: 00
This is a list of disabled zone-addresses. Scroll to or write the wanted
zone-address and press "A". If more zone-addresses are to be re-
enabled, repeat the procedure.
Disable / Re-enable control (X8)
001 ZONE-ADDR 12-45 LAST ZONE 12
Disable/Re-enable control
Press "A". E.g.:
001 ZONE-ADDR 12-45 LAST ZONE 12
Dis(=0) or re-en(=1) control? 1
To disable, press "0" and "A". (To re-enable, press "1" and "A".). For
more information, see chapter "Disable all control, extinguishing,
ventilation and alarm device outputs (H2/B4), page 85.
Disable / Re-enable alarm devices (X9)
001 ZONE-ADDR 12-45 LAST ZONE 12
Disable/Re-enable alarm dev. ACCEPT?
Press "A". E.g.:
001 ZONE-ADDR 12-45 LAST ZONE 12
Dis(=0) or re-en(=1) alarm dev?1 ACCEPT?
To disable, press "0" and "A". (To re-enable, press "1" and "A".). For
more information, see chapter "Re-enable all control, extinguishing,
ventilation or alarm device outputs (H2/B8), page 90.

Alert Annunciation alarm (AA alarm)

Indications, actions etc. as for a normal fire alarm except that
EBL128 output for routing equipment (Fire brigade tx) will not be
activated directly. An AA alarm is indicated by the LED "Fire
brigade tx delay" (L16). The AA alarm has to be acknowledged
within an acknowledge time and reset within and an investigation
45
EBL128 Operating Instructions V1.1.x
No. 01
ACCEPT?
No. 01
ACCEPT? X7
No. 01
ACCEPT?
No. 01
ACCEPT? X8
No. 01
ACCEPT?
No. 01
X9
No. 01