Mitsubishi Electric HD-6000 Owner's Manual page 106

Troubleshooting, continued
PossibJe SoJution
50.
TV PAUSE does not start when the PAUSE key
is pressed.
If there is a fulI screen pause without a slider appearing, then TV
Pause is off. Go to the Setup menu and change the TV Pause
setting from Off to Always or On Request. Press Pause.
TV Pause needs to be restarted. Press DEVICE to display the
Device Selection menu and press ENTER. Press Pause.
Power the HD-6000 off and then on. Press Pause.
Can't use TV Pause while recording an analog program.
See Reset Menu instructions at the end of the Troubleshooting
guide.
, _ TV Pause is not available when PIP/POP is displayed.
51. When viewing a PC screen on the LT-4260 with _ Turn the PC Power Saver to Off, to prevent the LT-4260 and HD-6000
PC Power Saver turned On, the LT-4260 and turning off.
HD-6000 turn off.
Using The System Reset Button
If the HD-6000 doesn't respond to either the
remote controi or the front panei controis or wiii
not power off, press the SYSTEM RESET button
on the front panei with a pointed item such as the
point of a bah point pen or end tip of a paperciip.
The HD-6000 wiii turn off and the blue led wiii flash
quickly for about one minute. When the blue led
stops flashing, you may turn on the HD-6000 again.
The changes you made whiHethe HD-6000 was
most recently on, before you used the SYSTEM
RESET button may lost, however, the changes you
made previously are not IosL Only those changes
since the last power On may be lost when the
system reset button is pressed. Aii other settings
are retained.
Using the Reset Menu for Reset
of the HD-6000 or TV Disc
Press TV menu followed by 1,2,3 to see the RESET
SERVICE MENU to reset the HD-6000 or TV Disc.
Select a device other than TV Disc before using this
menu.
Read on-screen warnings before
proceeding, as some user data or
settings may be erased.
Your choices are:
OP
2.
Reset System Defaults (CAUTmON: All settings,
except V-Chip, wiii be reset to the original
factory defaults).
Erase TV Disc (CAUTION: Track List wiii be
cleared).
3. Reformat TV Disc (CAUTION: Track List wiii be
cleared).
4. Reset TV Disc (Track List wiii not be affected).
106