Setup Menu - Mitsubishi Electric HD-6000 Owner's Manual

Setup Menu
Setup Menu
Figure 8
Press ADJUST A or T to navigate between cobrs
and ADJUST _ or _ to change the cobr siider
settings.
Figure 8. Setup Menu, NetCommand Option
Language
Dispiay the on-screen menus in either Engiish or
Spanish (Espa_oi). The first time you powered On your
HDTV receiver/controller, you were requested to sebct
an on-screen menu ianguage. If you choose to change
the sebction, aH menu text will immedbteiy switch to
the ianguage of your choice.
Program titles and other information sent by a
broadcaster wiii be shown in the originai language.
CoJor Balance
Your HD-6000 uses six coiors (Magenta, Red, Yellow,
Green, Cyan and Biue) to create coior baiance. You may
adjust the intensity of the colors automatically or manually
(PerfectColor TM)or reset them to the default settings.
Each input or device has a memory for PerfectColor.
Auto (Color Balance}
If the Auto box is checked, your HD-6000 will optimize
color automatically and continuously. Both PerfectColor
and Reset options for Color Balance are grayed out and
unavailable.
PerfectComor
TM
(Manuam Comor Bamance}
Figure 9
The PerfectColor (manual) option is only available when
Auto (Color Balance) is not checked. Select PerfectColor
and press ENTER to display the menu. Individual sliders
for Magenta, Red, Yellow, Green, Cyan and Blue will be
displayed. The sliders have a numeric value, where 63
is the maximum. The default setting for each color is 31
(center). Highlighted text will show which slider you are
adjusting. Each active input can be individually adjusted.
Figure 9. PerfectColor Menu, Manual Color Correction
Reset
Select to reset the Color Balance settings. Each active
input can be individually reset, if Auto is not checked.
TV Pause
TV Pause is a special feature of the internal TV Disc
digital video recorder (DVR). TV Pause is available
for CabbCARD TM,Ant-l, Ant-2, IEEE 1394 input and
tuning devices (cable boxes or satellite receivers
connected to Inputs 1 or 2).
This feature allows you to press PAUSE to "pause"
live TV. You can then search backwards or forwards
through the current TV program. When you pause
the TV program, an on-screen slider will show
approximately how far and in which direction(s) you
can search.
TV Pause has three settings:
On Request: This is the default setting. TV Pause
is in the standby mode until you press PAUSE
for the first time after turning on the TV, or after
a channel or device change. There will be a few
seconds delay before a paused picture appears.
During this pause, you will not be able to scan or
skip backwards in the TV Program. Later uses of
TV Pause while in the same program, will allow
reverse scan or skip of the available TV program
as shown on the slider. The TV Pause will return to
the standby mode automatically when you change
the channel or device. The PIP/POP features are
available only when TV Pause is in the standby
mode and not enabled.
Always: Press PAUSE, REW, FF or any ADJUST
button to pause the program and scan or skip
within the program. You can also scan or skip
69