Netcommand® Onscreen Buttons - Mitsubishi Electric HD-6000 Owner's Manual

NetCommand® On Screen Buttons
To use the HDTV receiver's NetCommand feature, you need to provide some detaibd information during the setup.
You must define the manufacturer of the devices that are connected to the HDTV receiver, or barn the IR code
remote controi signais for the device connected. For each device, the input to the HDTV receiver and AiV receiver,
and the names for the device are pre-set during Bnitiai NetCommand setup. You may change those inputs or names
using the Edit NetCommand or Learn screens. The buttons described bellow will heip you navigate the screens.
On your remote controi, the ADJUST _ and • buttons
allow you to navigate Heftand right to different
sebcfions on the screen. The ADJUST • and V
buttons allow you to:
Change the radio button
Change current text box sebction
Navigate up and down on the screen
The ENTER button allows you to:
Confirm the selected character when naming a
device
Add or delete check marks in check boxes
o Select on-screen buttons to change screens
Text Box
Control Buttons
Much like the software on your computer, you will use
graphic buttons to navigate through the NetCommand
Setup screen. Highlight the button and press ENTER
to select the function.
<Back Button
Use the <Back button to navigate back to the previous
screen.
Next> Button
Use the Next> button to navigate forward to the next
screen.
CanceJ Button
Press ADJUST • or • to make a selection.
Check Box
Check marks indicate the item or input is added or
turned On. Press ENTER when the check box is
highlighted to add or delete a check mark. When
viewing the Review screen, a check box reflects which
devices are turned On or Off, or connected to the
HDTV receiver.
Radio Buttons
The Cancel button wiii cancel out any changes you
are currently making without saving them into memory.
When you select the Cancel key, NetCommand
wiii prompt you to confirm that you want to cancel
the changes you are currently making. If you
select Cancel during Initial Setup, you can setup
NetCommand later by selecting the NetCommand
menu, then choosing Initial.
The setting changes when one of the choices is
41