Mitsubishi Electric HD-6000 Owner's Manual page 46

Edit NetCommand ®, Add an AiV Receiver, continued
A/V Receiver input Learn Screen
Figure 8
NetCommand can now barn the remote controi
signais used to sebct each input on the AiV receiver.
1. Press ADJUST _ or _ on the HDTV receiver/
controller remote to sebct the check box for each
function to be bamed.
2. Press ENTER and the function name will begin to
flash to confirm the ready-toqeam status.
3. Point the AiV receiver's remote controi at the TV
screen. Press the button on the remote controi that
corresponds to the sebcted function. A check
mark will appear and the function name will stop
flasMng. This confirms the signai bamed status.
4. To test the bamed command, whiie the function
is sebcted, press ENTER on the HDTV receiver, /
controller remote. The A/V receiver will perform the
sebcted function. The AiV receiver needs to be
turned on and the IR emitters properly placed for
the test to be successful (see page 30 for IR emitter
placement).
5. To customize the input names, press ADJUST _ to
move to the Input Name text box and then press
ADJUST A or • and ENTER to select each letter of
the name. These names will appear on the Review
screen as the AiV receiver's input names.
6. To erase the learned input signal, highlight the
check box for that input and press CANCEL
7. Repeat for each connected inpuL
8. When the input selection signals have been learned
and the inputs named, press ADJUST _ to select
Next> and move to the A/V receiver Learn screen.
Figure 8, A/V receiver Input Learn screen
A/V Receiver Learn Screen
Figure 9
1. Press ADJUST _ or _ on the HDTV receiver/
controller remote to select the check box for each
function to be learned.
2. Press ENTER and the function name wiii begin to
flash to confirm the ready-to-learn status.
3. Press the button on the AiV receiver's remote
control that corresponds to the selected function,
A check mark will appear and the function name
will stop flashing. This confirms the signal learned
status.
4_
To test the learned command, press ENTER on the
HDTV receiver/controller remote. The AiV receiver
wiii perform the selected function. The AiV receiver
needs to be turned on and the IR emitters properly
placed for the test to be successful (see page 30 for
5. Repeat for each function to be learned.
6. To erase a learned function, highlight the check box
for that function and press CANCEL
7. When the function signals have been learned, press
ADJUST _ to select Next> and move to the Name
screen.
Figure 9. A/V receiver Learn screen
Hint: If your A/V receiver remote control uses a single
button for both Power On and Power Off, don't learn
the Power Off function, if your A/V receiver uses a
single button to toggle between digital and analog
sound, then learn only Analog to Digital. if your A/V
receiver automaticafly switches between analog and
digital audio, then you don't need to learn either
Analog to Digital or Digital to Analog functions.
46