Mitsubishi Electric HD-6000 Owner's Manual page 51

Edit NetCommand ®, Add Devices, continued
The screens described bemow may not be necessary for your device setup. If they do not dispmay
automatically on-screen, they are not required.
VCR for Recordings Screen
Figure 20
If more than one anaHog VCR is connected to the HDTV
receiver/controller, you need to seHect the one to be
used for recording. You may aHsoseHect whether you
want the recorded 16:9 signaHsfrom digitaH channeHs
or EEE-1394 devices to be cropped (sides are cut off)
or AnamorpMc (full screen). If Anamorphic is seHected
for viewing, choose the Standard format for the best
quaHity pHayback.
lnputoDTV Connection Screen
Figure 22
This screen dispHays only if the device seHected k_the
Connection screen (Figure 19) is connected to hput-
DTV_ This is usually DBS, but can be Cable Box_ The
Input-DTV Connection screen allows you to select the
connection type, RGB (HV) or Component YPbPr you
are using to connect your cable box or DBS.
Figure 20. VCR for Recordings screen
RF Connection for CabJe Screen
Figure 21
The RF Connection screen displays only when
adding or changing a Cable Box. if your Cable Box
is connected to a HDTV receiver/controller antenna
input, check the RF checkbox. Select the antenna
input that is used with the Cable Box. Select the
channel number used for output by your cable box.
The default channel is 003. if the Cable Box is also
connected to a VCR for recording, select that VCR.
If your Cable box is connected using Audio/Video
cables, make sure the RF checkbox is unchecked.
Then the next screen will be Connection (Figure 19),
to allow the selection of the HDTV receiver/controller
input used with the Cable Box.
Figure 2!. RF Connection for Cab/e screen
Figure 22./nput-DTV Connection screen
IR Code for [Device] Screen
Figure 23
This screen only displays if an added device has the
same IR code as a previously added device of the same
type and manufacturer. You can specify the IR setting for
the new device. For example, for the second Mitsubishi
VCR you can specify the IR Code setting to VCR-B, if the
primary Mitsubishi VCR is using the VCR-A IR code.
Figure 23./R Code for [Device] screen
51