Netcommand® Lnitiau Setup - Mitsubishi Electric HD-6000 Owner's Manual

NetCommand ® lnitia Setup
When you first power On your new MitsubisM HDTV
receiver, the initiaHsetup screens appear. Most IR
remote controH signaH formats can be Hearned by
NetCommand.
IMPORTANT: To program the remote control to
operate the HD-6000, slide to the CabIe/DBS/DTV
position then press and hold the POWER while
entering the numbers 1,9,7 in sequence, then release
the POWER key.
WeJcome Screen
Figure 1
When you first turn on your HDTV receiver, the
WeHcome screen dispHays and asks you to seHect
either EngHish or Spanish as the Hanguage for the on-
screen menus. The default Hanguage is EngHish. To
change Language Hater,seHect Setup in the Main Menu.
SeHecting Oancel at this screen will cause the defauHt
Hanguage (EngHish) to be seHected.
Figure 1. We/come screen
NetCommand (Information} Screen
Figure 2
The NetCommand (Information) Screen describes
how to start or delay the initial NetCommand Setup.
This screen displays automatically the first time you
power On your new HDTV receiver, after the Welcome
screen. To setup NetCommand, select Next> and
Figure 2, information screen
If the NetCommand Setup is cancelled before it's
completed, you can restart the NetCommand setup
by:
1. A press of TV MENU on the remote control to
display the TV Main menu.
2. Select NetCommand. The available options will
be: Add, Review and Initial. Change and Delete
will be grayed out.
3. Press ADJUST ,&, _V',_ or _ to select Initial.
4. Press ENTER. The Device Setup screen displays.
Device Setup Screen
Figure 3
If the devices connected to the HDTV receiver/
controller are already in NetCommand memory,
you can quickly select them at this screen. Press
ADJUST _ or _ to move to each device type.
Press ADJUST A or 'V to select the manufacturer.
Select "Other" if the manufacturer is not listed.
Later, you can use the Change setting in the Edit
NetCommand menu to learn the remote control
signals for this device. Select "None" for device
types that are not connected.
For the AiV Receiver, if the manufacturer is not
listed, you cannot select "Other". Instead, select
"None". Later, you can use the "Add" feature in the
NetCommand menu to have the HDTV receiver add
and learn the remote control signals for this device.
After completing your choices, select Next> and
Figure 3, Device Setup screen
43