Battery Installation; Care - Mitsubishi Electric HD-6000 Owner's Manual

Remote ControJ Functions:Operation and Care, SJeep Timer
CAB__/DBS/D_ VCR _VO
Iw _ _ i _AUDIO
RM-6000
PAUSE (
Figure 1. Remote Control Overview
Battery installation
Figure 2
installing the Batteries:
1. Remove the remote control's back cover by gently
pressing the ribbed tab in the direction of the arrow
and sliding off the cover.
2. Load the batteries, making sure the polarities (+) and
(-) are correcL For best results, insert the negative
(-) side firsL
AA (alkaline)
b_tterie_
Care
For Best Results from the Remote Control:
• Be within 20 feet of the equipment.
• Do not press two or more buttons at the same
time unless instructe&
Do not allow unit to get wet or become heated.
Avoid dropping on hard surfaces.
Do not use harsh chemicais to clean. Use only
a soft, lightJymoistened cloth.
Do not mix new and old batteries.
Do not heat, take apart or throw batteries into
fire.
Use onlyAA aIkaIine batteries.
Hint: /f the remote is in the Cab/e/DBS/DTV
layer and will not operate the HD-6000, press
and hold POWER and enter 1,9,7 to reset the
remote.
SJeep Timer
Setting the Sleep Timer:
1. Press SLEEP on the remote control.
2. Each press of SLEEP increases the time displayed
by 30 minutes, until the maximum value of 120
minutes is reached.
3. After 5 seconds of inactivity, the message will
disappear.
4, Press SLEEP to view the remaining time before the
timer turns the TV off.
Canceling the Sleep Timer:
1. Press SLEEP to display the on-screen message.
2. Press SLEEP repeatedly until OFF is displayed.
Note: After 5 seconds of inactivity, the message
box disappears.
Figure 2. Operation: Installing the Batteries
4O