Setting Up The Ethernet/Wireless Lan Client; Setting Up Ethernet Client - Toshiba WRC-1000 User Manual

Wireless routing center

Hide thumbs Also See for WRC-1000:

Specifications (1 page)

Table Of Contents

100

101

102

103

104

105

106

Table of Contents

Setting up the Ethernet/Wireless LAN

client

To access the Wireless Routing Center via Ethernet or wireless network, you must

properly configure the network settings of your Ethernet or wireless client com-

puter. As the Wireless Routing Center is configured with the default IP address of

192.168.10.1 and subnet mask of 255.255.255.0, and its DHCP server is enabled

by default, you can configure your computer's TCP/IP settings as one of the

following:

1. To use dynamic IP: Set your computer to be DHCP client to accept the

dynamic IP from the router.

2. To use static IP: Set the IP address as 192.168.10.x (x is between 2 and 254),

subnet mask as 255.255.255.0 and the gateway as 192.168.10.1 to be on the

same subnet with the router.

This section describes how to configure your computer to be a DHCP client for

initial connection to the Wireless Routing Center. If you have modified the

Wireless Routing Center's network setting, your LAN/Wireless LAN clients

should make appropriate changes in order to make a successful connection.

Setting up Ethernet client

To access the Wireless Routing Center via Ethernet, make sure your computer is

equipped with an Ethernet network card and has an appropriate network card

driver and TCP/IP installed.

NOTES: 1. If TCP/IP protocol is not installed on your computer, refer

to Windows documentation for installation instructions.

2. For initial verification, connect only one computer directly

to an Ethernet port on the Wireless Routing Center, not

through a hub. Connecting more than one computer may

cause setting errors.

For Windows XP

1. From the Start menu, point to Connect To and then click Show all

connections.