Table of Contents
Advertisement
Windows 2000
1. Click Start, point to Programs, Accessories and click
Command Prompt to open the Command Prompt window.
2. Enter ipconfig and press Enter.
3. Check the values for the IP address and subnet mask.
IP address : 192.168.10.100 – 192.168.10.150
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.10.1
If the TCP/IP protocol has not been installed, or if the correct IP
address has not been set, read the manuals for your computer and
LAN card and set them accordingly.
If you want to configure the IP address, refer to the
Ethernet/Wireless LAN client
information.
Windows 98/Me
1. Click Start and Run..., then enter winipcfg in the input box.
2. Check the values for the IP address and subnet mask in the
winipcfg dialog box. In an ordinary small-scale LAN environment,
the subnet mask is set to 255.255.255.0.
In this case, confirm that the first three sets of digits of the IP
address of the Wireless LAN station are the same as those of the
IP address of the Wireless Routing Center. It corresponds to
192.168.10.x if the Wireless Routing Center's default of
192.168.10.1 is used.
If you want to configure the IP address, refer to the
Ethernet/Wireless LAN client
information.
Wireless LAN
section in Chapter 3, Setup, for more
section in Chapter 3, Setup, for more
Setting up the
Setting up the
5-5
Advertisement
Table of Contents
