Table of Contents
Advertisement
3. Check the values for the IP address and subnet mask in the
winipcfg dialog box. In an ordinary small-scale LAN environment,
the subnet mask is set to 255.255.255.0.
NOTE: In the case where the Wireless Routing Center's setting is default,
the IP address is 192.168.10.1, Subnet Mask is 255.255.255.0.
If the TCP/IP protocol has not been installed, or if the correct IP
address has not been set, read the manuals for your computer and
LAN card and set them accordingly.
Cause 3
The Configuration window might not be displayed if Proxy Server has
been set.
Remedy Set not to use Proxy Server. You can enable it later.
The user name and password are not accepted despite repeated entries.
Cause
The wrong user name and password have been entered.
Remedy If the User name and Password was changed in Administrator
Account, enter those values. If you have forgotten them, reset to the
defaults. Refer to the
Wireless LAN
There is no communication between a Wireless LAN station and other computers.
Cause 1
The functions of Wireless LAN stations have not been correctly
installed.
Remedy Read the manual for your Wireless LAN PC card, and check that the
driver has been installed and is operating correctly.
If you are using a TOSHIBA Wireless LAN PC card in a computer
running Windows 2000, follow the steps below.
1. Click Start, point to Control Panel and click System to open
the dialog for System Properties.
2. Click the Hardware tab, then double-click Device Manager, to
open the Device Manager window.
3. From the Network Adapters item, double-click TOSHIBA
Wireless LAN Card, to open the TOSHIBA Wireless LAN
Card Properties dialog box.
4. If the message This device is working properly is
shown in the item Device Status, it indicates that the driver
has been installed and is operating.
Load Default
item in Chapter 2, The Grand Tour.
Wireless LAN
5-3
Advertisement
Table of Contents
