Table of Contents
Advertisement
User's Manual
Cause 2
The settings of Wireless LAN stations are different from those of the
Wireless Routing Center.
Remedy Make sure the following settings are the same on the Wireless LAN
stations and the Wireless Routing Center.
SSID (Network Name)
Basic rate not higher than the communication rate of the Wireless
LAN PC cards in the Wireless LAN stations
WEP mode disable/64 bits/128 bits
WEP key settings correspond between devices when Encryption is
enabled
Access Control enable/disable
MAC Address of Wireless LAN PC card correctly registered if
Access Control is enabled
Cause 3
TCP/IP has not been set, or has been improperly set at one or more of
the computers.
Remedy Confirm that the IP address has been correctly set.
Windows XP
1. Click Start, point to All Programs, Accessories and click
Command Prompt to open the Command Prompt window.
2. Enter ipconfig and press Enter.
3. Check the values for the IP address and subnet mask.
IP address : 192.168.10.100 – 192.168.10.150
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.10.1
If the TCP/IP protocol has not been installed, or if the correct IP
address has not been set, read the manuals for your computer and
LAN card and set them accordingly.
If you want to configure the IP address, refer to the
Ethernet/Wireless LAN client
information.
5-4
section in Chapter 3, Setup, for more
Setting up the
Advertisement
Table of Contents
