Fujitsu PRIMERGY RX200 S2 User Manual page 61

Hexad
ecimal
ID Type
notatio
n
22 (0x16) Warn
ing
23 (0x17) Warn
ing
24 (0x18) Warn
ing
25 (0x19) Infor
mati
on
28 (0x1c) Error
33 (0x21) Error
Log item
Parity error found. A parity error was
detected.
Soft error found. An error was detected
in a hard disk, but it
was resolved.
Misc error found. • A hard disk reported
• The Read/Write
• A hard disk is busy.
SCSI device reset. The firmware issued a
reset for recovery.
Request Sense Data A hard disk reported
available. sense information.
A physical disk A hard disk failed.
failed because write
recovery failed.
Description
Replace the SCSI BP or
SCSI cable.
If there is a Dead hard
disk, perform the rebuild
process. If multiple hard
disks are dead, perform
the recovery procedure
using the Multi Dead
function.
Not required.
If this frequently occurs,
replace the hard disk as a
precautionary measure.
Because a recovery is
an error. being performed, no
action is required.
command timed out. If this frequently occurs,
replace the hard disk as a
precautionary measure.
Check the logs
surrounding the process
and perform necessary
actions.
Because the SCSI array
controller is implementing
a recovery, no action is
required as long as the
corresponding disk is
Online.
For GAM Client, the
message displayed is
replaced with a
description indicated by
sense information.
Replace the hard disk and
perform the rebuild
process. If a Multi Dead
occurred, take corrective
action using the Multi
Dead function.
Action
B List of GAM Error Codes
61