Fujitsu PRIMERGY RX200 S2 User Manual page 65

Hexad
ecimal
ID Type
notatio
n
71 (0x47) Error
72 (0x48) Error
73 (0x49) Infor
mati
on
74 (0x4a) Infor
mati
on
75 (0x4b) Warn
ing
80 (0x50) Warn
ing
81 (0x51) Infor
mati
on
86 (0x56) Infor
mati
on
126 (0x7e) -
132 (0x84) Error
Log item
Mirror Race Writing of write buffer
recovery failed for failed.
logical drive.
Controller A checksum error in
parameters the controller
checksum parameter was
verification failed -- detected.
restored default.
Online controller Firmware upgrade
firmware upgrade started.
has started.
Online firmware Firmware upgrade
upgrade has completed.
completed
successfully.
Online firmware Firmware upgrade
upgrade has failed. failed.
Firmware entered The firmware is now in
unexpected state at an unexpected state.
run-time.
Rebuild stopped on Due to a controller
controller failure. error, a rebuild stopped.
Rebuild resumed. Rebuild restarted.
Firmware corrected A media error was
the 'Read' error. corrected.
Consistency check The consistency check
on logical drive terminated abnormally
failed. due to a bad logical
drive.
Description
If a hard disk is dead,
replace it. If this occurs
repeatedly, replace the
baseboard.
Check the setting in SCSI
Setup and change it to the
appropriate setting.
Not required.
Not required.
Try to upgrade the
firmware again. If it fails,
replace the SCSI array
controller.
The firmware may be
frozen. Replace the
baseboard.
Replace the baseboard and
perform the rebuild
process again.
Not required.
Not required.
Take corrective action
using the Temporary
Offline function.
In case of RAID10, run
the Consistency Check
again.
B List of GAM Error Codes
Action
65