Diagnostic Codes And Causes - Siemens SIMATIC FS600 Instruction Manual

15

Diagnostic Codes and Causes

Loca- Description
tion
102 Processing of commands,
processing of messages
103 Control of command
processing
104 Processing of commands,
Processing of configuration
105 Processing of commands,
generation of output
messages
201 Processing of the receive
protocol
302 Processing of the transmit
protocol
306 Output of measurement
values
801 Event processing
805 Processing of the commands
to the event memory
1002 Motor control during
initialization
1002 Motor control during
initialization
1110 Test of the switch outputs.
1110 Test of the switch outputs.
1110 Test of the switch outputs.
1111 Short circuit test of switch
outputs
1111 Short circuit test of switch
outputs
1606 Motor speed monitoring
1607 Monitoring of duration
of a scan
106
No. Description
2 Data transmission error on the X2
interface
2 Data transmission error on the X2
interface
2 Data transmission error on the X2
interface
6 Function, access, command not
permitted with currently selected
authorization level
4 Too much data sent over the X2
interface. Message will be
overwritten by new message
2 The verification of displayed data
remained unacknowledged for too
long.
5 Previous message not yet
completely output
2 Event memory cannot be read,
internal fault
6 Event memory cannot be
transferred. Data transmission error
on interface X2
1 Motor does not reach rated speed
after start. Internal fault.
2 Motor speed not constant after start.
Internal fault.
4 Switch outputs (OSSD) have
a state other than the one the
scanner expected. Possible wiring
or control error
5 Switch output (OSSD) cannot be
switched off
6 Switch output (OSSD) cannot be
switched on
7 Short circuit of a switch output
(OSSD) with ground
8 Short circuit of a switch output
(OSSD) with Vcc
4 Motor speed deviation, zero pulse
not detected properly,
internal fault
5 Motor speed deviation, motor not at
rated speed