Siemens SIMATIC FS600 Instruction Manual page 88

13) Is the SIMATIC FS600 Laser Scanner able to cover the entire
danger area? Are dead zones excluded?
14) Has the effectiveness of the activated detection zone been
tested with the black test piece (70-mm diameter)?
15) Does the base mark match the correctly identified detection
zone?
16) Is the start/restart button for resetting the SIMATIC FS600 Laser
Scanner positioned according to requirements and does it work
properly?
17) Does the SIMATIC FS600 Laser Scanner work in all necessary
operating modes and during the entire motion of the machine
that is causing a hazard?
18) Is the motion causing the hazard stopped when electrical power
to the SIMATIC FS600 Laser Scanner is disconnected and is a
confirmation of the Start/restart key necessary to reset the
machine after the power is restored?
19) Are all test and parameter inaccessible to unauthorized
personnel?
20) Is an identifying sign placed on the machine for the daily test of
the SIMATIC FS600 Laser Scanner where it is clearly visible for
operating personnel?
88
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No