NEC Xen IPK Installation Manual page 100

June 2004
94 - Appendix C
To remove the existing network protocol configuration
1 Shut down the voice messaging system application by pressing ESC at
the Banner screen and then following the system prompts.
2 At the OS/2 command prompt, type
3 Type cd \ and press ENTER.
4 Type setup and press ENTER.
5 Type y to proceed with the voice messaging system Setup utility.
6 Press ENTER to continue until you reach the Setup Type menu.
7 From the Setup Type menu, type 3 to choose "Remove configuration"
and press ENTER.
8 Press ENTER to confirm that the voice messaging software is installed
on drive E.
9 Press ENTER to confirm that the voice messaging software is installed in
the Vmail directory.
10 Review the features and options available with your system that are
listed on-screen. Press ENTER to continue.
11 From the Remove Configuration menu, type 3 to reconfigure network
protocols and press ENTER.
12 When you have completed your selection(s), press ENTER.
13 Follow the on-screen instructions to continue.
14 From the Setup Complete menu, type y and press ENTER to exit the
Setup utility.
15 At an OS/2 command prompt, type shutdown and press ENTER.
16 Shut down and restart the voice messaging system by setting the
board's Shutdown switch Off. After the system has shut down, set the
switch On and then press the Power button to restart.
NEC Business Solutions Ltd
f: and press ENTER.
Changing Network Protocols