NEC Xen IPK Installation Manual page 94

June 2004 NEC Business Solutions Ltd
A Backplate Connector
B SW2:
Do not use. Keep the default settings as illustrated.
C SW1:
Do not use. Keep the default settings as illustrated.
D Expansion Board Cable
E Modem connector
F Hard Drive LED:
Indicates hard disk activity.
H LAN connector
I Keyboard connector
J Mouse connector
K COM (serial) port connector
L VGA Monitor connector
M SW3:
By default, dip switch #1 is set to Off so that the voice messaging system
application starts when the board is turned on. Set the switch On to only
start OS/2 software.
By default, dip switch #2 is set Off for direct (serial) remote access
connections. Set the switch On for modem connections.
Switches #3 and #4 are not used. Keep the default settings as illustrated.
N Power button:
Do not use. Cuts the power to the board from the PC and the hard drive.
O Software LED:
Voice messaging software LED is green when the software is active, amber
when active with possible application problem, and red when inactive or
shut down.
P Shutdown switch:
By default, the switch is set On. Before turning off the phone system and
disconnecting the system board, set the switch Off to shut down the
software and system board properly.
Before restarting, set On. The board restarts only when the switch is on.
88 - Appendix A About the System Board