NEC Xen IPK Installation Manual page 27

Xen IPK Xen Mail CTI Installation Guide
Setting Up the System
To set up the voice messaging system software, continued
1 From the TeLANophy Server Name menu, perform one of the following
actions:
• To enter a name for the voicemail server, type m and press ENTER. Type the
server name and press ENTER.
• To use the default server name, press ENTER. "Vserver" is the default
server name.
2 Confirm your entry is correct. Press ENTER to continue.
3 Select the network protocols that you want the voicemail server to use to
communicate with the TeLANophy workstations:
• To select "IPX/SPX," type 1 and press ENTER.
• To select "TCP/IP," type 2 and press ENTER.
NOTE: If you have not configured either of these protocols, an error message
is displayed. Follow the on-screen instructions to continue.
4 When you have completed your selection(s), press ENTER.
5 If you chose to add language prompts in step 13, follow the on-screen
instructions to configure the system for these features.
6 From the Setup Complete menu, type y and press ENTER to exit the
Setup utility.
7 Shut down and restart the voice messaging system by setting the
board's Shutdown switch Off. After the system has shut down, set the
switch On and then press the Power button to restart.
NOTE: A system with incorrect protocol information cannot connect to the
LAN. To reenter the correct values, perform the procedure, "To change
an existing network protocol configuration."
Chapter 2 - 21