NEC Xen IPK Installation Manual page 51

Xen IPK Xen Mail CTI Installation Guide
Backing Up & Restoring the System
15 If you selected "Version 4.x directory service," perform the following
actions:
m
• Type and press ENTER. Type the correct value for the "NetWare name
context" field and press ENTER.
• Confirm your entry is correct. Press ENTER to continue.
• Type m and press ENTER. Type the correct value for the "Preferred Net-
Ware server name" field and press ENTER.
• Confirm your entry is correct. Press ENTER to continue.
16 From the Ethernet Frame Header menu, perform the appropriate action
below:
• To select "Ethernet 802.2," type
• To select "Ethernet 802.3," type
• To select "Ethernet Snap," type
• To select "Ethernet II," type
To install network protocols for backups, continued
1 When you have completed your selection, press ENTER to continue.
2 If you selected NetBIOS over TCP/IP, perform the following actions.
Otherwise, go to step 4.
1
• Type and press ENTER. In the "Workstation name" field, type the NT log
on name of the voice messaging system and press ENTER.
• Type 2 and press ENTER. In the "NT Domain name" field, type the voice
messaging system's NT domain name and press ENTER.
If no domain, type the Windows workgroup name in this field.
• Type 3 and press ENTER. In the "Workstation description" field, type a
description of the voice messaging system and press ENTER.
• Leave the "User" and "Password" fields blank.
3 Press ENTER to confirm your entries.
If you have not configured TCP/IP, an error message is dis-
NOTE:
played. Follow the on-screen instructions to continue.
4 Follow the on-screen instructions to continue.
5 When you reach the Setup Complete menu, press ENTER to exit the
Setup utility.
6 Shut down and restart the voice messaging system by setting the
board's Shutdown switch Off. After the system has shut down, set the
switch On and then press the Power button to restart.
A system with incorrect protocol information cannot connect to
NOTE:
the LAN. To reenter the correct values, perform the procedure,
"To change an existing network protocol configuration."
1
and press ENTER.
2 and press ENTER.
3 and press ENTER.
4 and press ENTER.
Chapter 4 - 45