NEC Xen IPK Installation Manual page 55

Xen IPK Xen Mail CTI Installation Guide
Backing Up & Restoring the System
additional servers as necessary.
To edit the Rconnect.cmd file
1 At the OS/2 command prompt, type e: and press ENTER.
2 Type cd \vmail and press ENTER.
3 Make a backup copy of the Rconnect.cmd file.
4 Using the OS/2 text editor, open the Rconnect.cmd file. To do so, type
tedit rconnect.cmd
and press ENTER.
5 Go to the line "set dozetime=10."
6 If necessary, replace 10 with the number of minutes between polls
made to the network by the Rconnect.cmd file. (If you set this field to a
higher number, it may take longer before subscribers are notified
that the network is down.)
7 Save the file and close it.
To edit the Startit.cmd file
1 At the OS/2 command prompt, type e: and press ENTER.
2 Type cd \vmail and press ENTER.
3 Make a backup copy of the Startit.cmd file.
4 Using the OS/2 text editor, open the Startit.cmd file. To do so, type
tedit startit.cmd
and press ENTER.
5 Go to the line
"rem <voice messaging system drive letter>: && cd \vmail && start
'background re-connect'
/f rconnect.cmd"
and remove rem from it. This sets up the Rconnect.cmd file to run auto-
matically when the voice messaging system restarts.
6 Save the file and close it.
7 At an OS/2 command prompt, type shutdown and press ENTER.
Chapter 4 - 49