Configuring Network Protocols For Telanophy - NEC Xen IPK Installation Manual

June 2004
S 2
E C T I O N
C
ONFIGURING
NETWORK PROTOCOLS
T LAN
FOR E OPHY
72 - Chapter 6
Perform the following procedure to set up or reconfigure network protocols
for
TeLANophy.
To configure network protocols for TeLANophy
1 Ask your network administrator for the information required to set up
network protocols. Refer to the table in Chapter 2 for details.
2 Shut down the voice messaging system application by pressing ESC at
the Banner screen and then following the system prompts.
3 To open an OS/2 command prompt from the voice messaging system
screens, do one of the following:
• If you are using a monitor, keyboard, and mouse plugged into the voice mes-
saging system board to access the voice messaging system screens, go to
the OS/2 desktop and select the OS/2 Window icon.
• If you are using a remote access connection to access the voice messaging
system screens, switch to the OS/2 Host Process Switcher window by press-
ing Esc+Alt. Type
ENTER.
4 At the OS/2 command prompt, type
5 Type and press ENTER.
cd \
6 Type and press ENTER.
setup
7 Type to proceed with the voice messaging system Setup utility.
y
8 Press ENTER to continue until you reach the Setup Type menu.
9 From the Setup Type menu, type
press ENTER.
10 Press ENTER until you reach the Update Configuration menu.
11 From the Update Configuration menu, type
network protocols for TeLANophy and press ENTER.
12 When you have completed your selection(s), press ENTER.
13 Follow the on-screen instructions to continue.
14 From the Setup Complete menu, type
Setup utility.
15 Shut down and restart the voice messaging system by setting the
board's Shutdown switch Off. After the system has shut down, set the
switch On and then press the Power button to restart.
A system with incorrect protocol information cannot connect to
NOTE:
the LAN. To reenter the correct values, perform the procedure,
see "To change an existing network protocol configuration."
to choose "Start a new 0S/2 text session" and press
0
and press ENTER.
f:
to choose "Configure system" and
2
and press ENTER to exit the
y
NEC Business Solutions Ltd
to configure or reconfigure
1
Setting Up TeLANophy