Clearing Your Configuration - NEC 2400 Integration Manual

Clearing Your Configuration

When you add voice mail ports or change the switch dial plan, you may need to
reconfigure the SID. In most cases, you can accomplish the task by editing the
existing setup and restarting the system. If required, the SID provides the
capability to restore the factory default settings.
To clear your configuration and restore the factory setting, use the following
instructions.
1. Press
2. Press
SETUP menu as shown in the following example:
SETUP
3. Press
screen as shown in the following example:
CLEAR SETUP?
4. Press
Press
configuration, you remove all global parameter information, dial plan,
logical terminal number information, and SMDI and MCI serial port
information. The contrast and Enhanced MWI handling settings are
restored to the factory defaults. The only information preserved are your
error logs and statistical tables. Using the clear command stops the
integration. You must configure and start the system to integrate calls.
to access the Main Menu.
FUNC
to select the Setup option. After you press the key, you see the
4
1-Params
4-Advanced
0
to select Clear. After you press the key, you see the Clear Setup
3
1-Yes
0
to cancel the clear and return to the SETUP menu.
2
to restore the factory default settings. When you clear your
1
Clearing Your Configuration
2-Ports 3-Clear
2-No
Issue 2 December 1995
A-9