2. Set the parity of the MCI link to even and the word length to 7 bits.
Use Table 4-2 and Table 4-3 to set the DIP-switches on the MCI I/O card
in the switch.
NOTE:
If you need more information for setting the baud rate, parity, and
DIP-switches on the NEAX 2400 MCI port, refer to the
documentation supplied with your switch or contact your switch
service representative.
Table 4-2. MCI I/O Port DIP-Switch SW01 or SW11 Settings for Switches 4
through 8
Switch
Setting
Number
ON
4
OFF
ON
5
OFF
ON
6
OFF
ON
7
OFF
ON
8
OFF
Connect the MCI Line to the Switch
Function
Parity bit valid
Parity bit invalid
Odd parity
Even parity
7 bits
8 bits
1 stop bit
2 stop bits
Send side FIFO is 1 byte
Send side FIFO is 64 bytes
Issue 2 December 1995
4-5