Saving And Starting The Configuration; Administer Serial Data Links - NEC 2400 Integration Manual

Saving and Starting the Configuration

After you administer the basic parameters and assign extensions and LTNs, you
must save the configuration. You also can start the integration at this point,
although you should perform the tasks in the "Administer Serial Data Links"
section to check the default settings for the MCI and SMDI communication links.
Use the following instructions to save the configuration and start the system.
1. Press
After you press the key, you see the SETUP menu.
2. Press
After you press the key and return to the MAIN MENU, the SID checks the
current configuration against the information you entered. Because you
made changes to the configuration, the SID places the following prompt
on the screen:
SAVE EDITS?
3. Press
After you press the key, the SID saves the information you entered and
shows the following message on the screen:
Setup Saved...
4. After a short pause, the SID places another prompt on the screen as
shown below:
START SYSTEM?
5. If you want to start the integration, press
If you are not ready to start the integration, press
After you press
SID pauses for a few seconds then starts the integration. When the integration
on the SID keypad.
FUNC
again to return to the MAIN MENU.
FUNC
1-Yes
to select Yes and save your configuration changes.
1
1-Yes
you see the Restarting System... message on the screen. The
1
Saving and Starting the Configuration
2-No
2-No
to select Yes.
1
to select NO.
2
Issue 2 December 1995
8-7