Changing System Parameters; Setting The Date And Time - NEC 2400 Integration Manual

12. To change the default stop bit value shown in the field, press the left or
right arrow key to toggle through the optional values. Stop pressing the
arrow keys when you find the stop bit value you want to use.
13. After you select a stop bit value, press
14. Press
the SMDI data link, return to step 2.
You have completed the MCI or SMDI configuration setup. The SID automatically
accepts and saves any information you change. Continue to the procedure in the
next section, "Changing System Parameters."

Changing System Parameters

The SID provides access to some adjustable global system parameters. You can
change the following two parameters:
Time and date
LCD contrast setting
Use the instructions in this section to change the two system parameters.

Setting the Date and Time

Set the date and time when you install your SID system so error log messages
are properly timestamped. Although the date and time are set at the factory, you
may need to change the time to correct differences in time zones. Follow the
instructions below to set the date and time.
1. Press
2. Press
3. Press
After you press the key, you see the DT/TM form as shown in the following
example. The cursor appears in the month field.
DT/TM
4. Place the cursor on the Date field.
5. Enter the correct date in the format MM/DD/YY (month/day/year) by
pressing
date field. If the date is correct, do not change the information and
proceed to the next step.
to return to the MCI MAIN MENU. If you need to reconfigure
FUNC
to access the MCI MAIN MENU.
FUNC
to access the UTILITIES menu.
2
to access the DATE AND TIME form.
2
Date:
Time
and typing the month, day, and year in each part of the
ENTER
Changing System Parameters
to confirm your choice.
ENTER
11/18/91
15:35:00
Issue 2 December 1995
8-11