NEC 2400 Integration Manual page 75

9. In the RSC (Route Restriction Class) field, you see a default value of 0.
Enter the correct RSC. After you press
field.
Contact your switch system administrator to determine if the default value
is correct.
10. In the SFC (Service Feature Class) field, you see a default value of 0. Enter
the correct SFC.
Contact your switch system administrator for the correct SFC value.
11. When you finish editing the final field, press
administration.
12. When you assign the first station data command for a Line Package, the
message PKG CHECK appears on the screen.
Check that the correct circuit card is in the correct slot and press
After you press
ENTER
If you continue to assign station data commands to the same Line
Package, you receive a WRT? message after entering the station
information.
Enter Y to confirm the information. After you
returns to the first field.
13. Repeat steps 5 through 12 for each analog voice mail port you need to
assign. For example, if you have already assigned extension 500 but you
still need to assign extensions 501, 502, and 503, return to Step 5 and
enter 501 as the second extension. Repeat the process until 502 and 503
have been assigned. When you finish entering the analog voice mail port
numbers, press to return to the Station Data Commands menu.
/
Proceed to the next section, "Assign Voice Mail Extensions to a UCD
Group."
Administer Analog Voice Mail Ports
the cursor moves to the SFC
ENTER
ENTER
the cursor returns to the first field.
Issue 2 December 1995
to confirm the station
.
ENTER
press the cursor
ENTER
7-5