Engineering Labels For Network Cables - Huawei AP3010DN-AGN Hardware Installation And Maintenance Manual

Huawei AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN
Hardware Installation and Maintenance Guide
Meaning of the label in
l
l

5.4.3 Engineering Labels for Network Cables

Applicable Ranges
The labels can be applied to Ethernet cables.
Label Content
Table 5-24
You can also decide the label content according to the actual environment. If the device is not
installed in the cabinet, for example, you can remove the cabinet number.
Table 5-24 Information on the Ethernet cables
Content
MN-B-C-D
MN-Z
Issue 11 (2015-05-18)
Figure 5-90
"ODF-G01-01-01-R" indicates that the local end of the optical fiber is connected to the
optical receiving terminal on row 01, column 01 of the ODF in row G, column 01 in the
machine room.
"A01-01-05-01-R" indicates that the opposite end of the optical fiber is connected to Optical
Receiving Interface 1 on Slot 05, chassis 01 in the cabinet on Row A, Column 01 in the
machine room.
shows the information on both sides of the labels affixed to Ethernet cables.
Meaning
MN: cabinet
number
B: chassis number Numbered in the bottom-up order with two digits, for
C: physical slot
number
D: network port
number
MN: cabinet
number
Z: Location
number
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Example
For example, A01 is the first cabinet in row A.
example, 01.
Numbered with two digits in top-down and left-right
order. For example, 01.
Numbered in the top-down and left-right orders. For
example, 01.
For example, B02 is the second cabinet in Row B.
Fill in the location number of the terminal device on
site. If the cable is connected to a device in a cabinet,
the serial numbers of the cabinet, the chassis, and the
Ethernet interface of the device should be specified.
For example, B02-03-12. If the cable is connected to
the Network Management Station (NMS), the
specific location of the NMS should be given.
5 Appendix
106