Wall Mounting - Huawei AP3010DN-AGN Hardware Installation And Maintenance Manual

Huawei AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN
Hardware Installation and Maintenance Guide
Figure 2-5 Cable deployment and AP installation

2.5.1 Wall Mounting

Mounting APs on a wall requires sheet metal mounting brackets and expansion screws. The
procedures are as follows:
1.
2.
Issue 11 (2015-05-18)
NOTE
l The AP5030DN and AP5130DN must have cables connected first before installation. Except the two
models, the procedures for installing the other models of indoor APs are the same unless otherwise
stated. The following figures use the AP7110DN-AGN as an example.
l If the AP surface is covered with protective film, remove it before installation.
Fix the mounting bracket to the wall, adjust the installation position, and use the marker to
mark the drilling positions where expansion screws are installed.
UP
Use a 6 mm drill bit to drill 25 mm to 30 mm deep holes in the drilling positions. Hammer
the expansion tubes into the holes until the expansion tubes are completely embedded into
the wall.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
59mm
UP
2 AP Installation
20