Table of Contents
Advertisement
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Scenario
High-density
stadiums
If antennas are embedded into APs, the deployment distance requirements on the antennas are those on APs.
2.5 Installing the AP
Remove the protective film on the surface before installation to prevent electrostatic discharge.
2.5.1 Installing the Device on a Wall
Mounting kits and expansion bolts are required to install the AP on a wall.
l
l
Issue 03 (2019-04-01)
Deployment Distance Requirement
Regardless of restrictions of EIRP and FCC standards and the number
of 5G channels:
l If the antennas are installed at a height less than 20 m, you are
advised to leave at least 12 m between 2.4G antennas and 4 m
between 5G antennas.
l If the antennas are installed 20 m or higher from the ground, you are
advised to leave at least 16 m between 2.4G antennas and 4 m
between 5G antennas.
Considering restrictions of EIRP and ETSI standards but not the
number of 5G channels:
l If the antennas are installed at a height less than 20 m, you are
advised to leave at least 12 m between 2.4G antennas and 3 m
between 5G antennas.
l If the antennas are installed 20 m or higher from the ground, you are
advised to leave at least 16 m between 2.4G antennas and 3 m
between 5G antennas.
NOTE
NOTE
NOTE
A wall for installing the device needs to meet the following requirements:
l
The wall can bear the weight of four times the total weight of the device and mounting bracket
without damage.
l
When the tightening torx of a screw reaches 12 N•m, the screw still properly works, without crack
or damage on the wall.
Installing an AP8082DN
Installing an AP8182DN
Copyright © Huawei Technologies Co., Ltd.
2 AP Installation
17
Advertisement
Table of Contents
