Table of Contents
Advertisement
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Step 5 Push the heat shrink tubing toward the connector until the tube covers the crimped part, and
then use a heat gun to heat the tube, as shown in
Figure 6-31 Heating the heat shrink tubing (JG terminal)
----End
6.1.2.5 Assembling the Cord End Terminal and the Power Cable
Context
Figure 6-32
Figure 6-32 Components of a cord end terminal and a power cable
A. Cord end terminal
Procedure
Step 1 Strip a part of the insulation to expose the cable conductor with a length of L1, as shown in
Figure
Issue 03 (2019-04-01)
shows the components of a cord end terminal and a power cable.
B. Insulation layer of a power cable
6-33. The recommended values of L1 are listed in
Copyright © Huawei Technologies Co., Ltd.
Figure
6-31.
C. Conductor of a power cable
Table
6-4.
6 Appendix
68
Advertisement
Table of Contents
