Huawei AP8082DN Hardware Installation And Maintenance Manual page 161

AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Table 6-29 Information on the Ethernet cables
Content
MN-B-C-D
MN-Z
The contents of the labels for network cables connecting hubs and devices or agents and the
network cables for other purposes should be specified according to actual connections. The
details are as follows:
l
l
l
The serial number on the hub, the network interface number of the agent or terminal, and the
location of the standalone device should be specified according to actual connections.
Label Example
Figure 6-163
Figure 6-163 Sample label on an Ethernet cable
A01
Issue 03 (2019-04-01)
Meaning
MN: cabinet
number
B: chassis
number
C: physical slot
number
D: network port
number
MN: cabinet
number
Z: Location
number
For a network cable connecting a hub and device, the label on the hub end should
indicate the numbers of the chassis and cabinet where the hub resides, and the serial
number on the hub. The label on the device end should indicate the number of the
chassis and cabinet where the device is located. If the device is a standalone device,
provide the specific position of the device.
For a network cable connecting a hub and an agent or terminal, the label on the agent or
terminal end should contain the serial number of the network interface. The definitions
of the cabinet number and chassis number are the same as those described in
If the hub is a standalone device without a cabinet or chassis, the label should contain
specific location information that identifies the hub.
shows a sample label on an Ethernet cable.
03 01 01
Copyright © Huawei Technologies Co., Ltd.
Example
For example, A01 is the first cabinet in row A.
Numbered in bottom-up order with two digits, for
example, 01.
Numbered with two digits in top-down and left-
right order. For example, 01.
Numbered in top-down and left-right orders. For
example, 01.
For example, B02 is the second cabinet in row B.
Fill in the location number of the terminal device
on site. If the cable is connected to a device in a
cabinet, specify the serial numbers of the cabinet,
the chassis, and the Ethernet interface of the device.
For example, B02-03-12. If the cable is connected
to the Network Management Station (NMS),
specify the specific location of the NMS.
6 Appendix
Table 6-29.
154