Table of Contents
Advertisement
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Figure 6-147 Installing a new mold in the COAX crimping tool
Keep the short side of the mold inwards and the long side outwards, with the teeth of the mold
aligning from the larger size to the smaller size.
Step 5 Hold the handles of the COAX crimping tools tightly to match the mold and the jaw
completely. Align the screw holes, as shown in
Figure 6-148 Aligning the screw holes
Step 6 Hold the handles of the COAX crimping tools with one hand. Tighten the two fastening
screws clockwise.
crimping tool.
Issue 03 (2019-04-01)
Figure 6-149
and
Figure
Copyright © Huawei Technologies Co., Ltd.
Figure
6-148.
6-150shows the mold installed in the COAX
6 Appendix
129
Advertisement
Table of Contents
