Table of Contents
Advertisement
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Note:
l For optical interface cards returned, the optical interfaces should be covered with
l In general, the analysis card will not be returned to you. If you have any special
l One Fault Tag should be adapted in one return category, such as RMA/Return/Analysis.
l The items marked with "*" are the mandatory fields that you must fill in.
6.7 Installation Checklist
Com
pone
nt
PoE
power
supply
Issue 03 (2019-04-01)
protection caps.
requirements, please contact Huawei.
Applic
No.
able
Scope
AC
Indepen
1
dent AC
Indepen
2
dent AC
Indepen
3
dent AC
Indepen
4
dent AC
5
AC card
6
AC card
7
AC card
Indepen
8
dent AC
Indepen
9
dent AC
1
General
2
General
Copyright © Huawei Technologies Co., Ltd.
Check Item
The air vent of the device is free from blockage to ensure
normal heat dissipation.
The power modules are securely installed with their captive
screws tightly fixed.
Four rubber pads are attached to specified positions on the
bottom of the AC before it is placed on a desk.
The AC is secured in the cabinet or rack by rack-mounting
brackets or guide rails (or trays), and floating nuts are
correctly secured.
The AC card is secured in the cabinet or rack by guide rails
or trays, and the guide rails or trays and floating nuts are
correctly secured.
The AC card is correctly inserted into the device slot and
secured using the ejector lever.
No pins on the backplane are bent when the AC card is
installed.
The AC is grounded using a ground cable, meeting surge
protection requirements.
When the AC directly connects to APs, location IDs of the
APs are provided at the cable connection points.
The proper PoE switch or power adapter is selected, meeting
AP power supply and onsite environment requirements.
To ensure that the PoE power meets requirements, the PoE
power supply device and APs must be connected through
CAT5E and CAT6E network cables, and the cable length
cannot exceed 100 m.
6 Appendix
163
Advertisement
Table of Contents
